📦Unboxing and Wiring Power

Step 1 - Unbox your Clyr Controller

Unbox your Clyr Controller. The outdoor-rated controller has a hinged cover with an IP67 rated gasket, which means you can mount this directly outdoors with the rest of your pool equipment!

Remove the controller from the box and open the hinged cover.

Inside the device you will find:

- Two control cables

- 20-24 Volt Power Supply

- Controller circuit board (PCB)

Step 2 - Connect your controller to power

Remove the control cables and power supply from the controller box.

Clyr Controller Unboxing

Power Option 1 - Use Pump Low Voltage

Use this option if you're hooking up a Clyr Lite controller or using a Clyr controller that doesn't need to control auxiliary relays.

Step 1 - Please turn your breaker off that powers your pump

Step 2 - Please remove the screws on the back lid of your pump

Hayward Pump with back panel removed

Step 3 - Please locate the four port terminal and find the COM and 12V ports.

For Hayward,

COM: Green

12V: Red

For Jandy and Pentair

COM: Black

12V: Red

Example Hayward RS485 Pump Connector

Step 4 - Remove existing wires

Step 5 - Using a four wire cable or an ethernet cable, please choose a color to screw into COM and 12V. If you have black and red, please screw the wires into the following:

COM: black

12V: red

Use the following image as a reference:

Direct wiring from Pump to Clyr /Clyr Lite Controller

Step 6 - Power on your breaker. The LED on your CLYR board should power up yellow 🎉

👍 Please proceed to the next step.

Power Option 2 - Clyr Voltage Supply

Step 1 - Take Clyr power supply and locate a 120VAC outlet at your pool equipment pad

Step 2 - Wire the the following leads

GND: black wire

12V: red wire

Example wiring connecting power supply to a Clyr Controller

Step 3 - The LED on your CLYR board should power up yellow

Last updated

Was this helpful?