Your equipment. Connected clearly.

Choose your equipment, follow the steps, and check the result. Short Clyr video clips sit beside the tasks they explain.

Start with the name on the equipment label. A similar-looking connector or another model from the same brand can need a different setup.

Understand Clyr networks →

Find your equipment

19 guides

Pumps

Waterway Power Defender

Connect a Power Defender through its supported RS-485 interface, match its remote-control settings, and verify speed control.

RS-485 data Pumps

Madimack InverFlow Plus

Set up capacity-based pump control and understand which control source has priority.

RS-485 data Pumps

Hayward Omni pump interface

Set up the supported HUA pump interface and check that commands reach the intended pump.

RS-485 data Pumps

BLACK+DECKER VS 2026

Use the external communications connector and the dedicated network shown in the 2026 installation tutorial.

Dedicated RS-485 Network 1 Chemistry & dosing

Madimack InverCHLOR salt system

Connect the RS-485 salt system, set an appropriate output, and verify operation with the pump running.

RS-485 data Heating & cooling

Madimack heat pumps

Use the shared Madimack heat-pump integration to select heating, cooling or automatic operation and verify the response.

Supported RS-485 interface Heating & cooling

Dry-contact pool heaters

Understand the heater-enable connection, configure the correct output, and check the complete heating and shutdown sequence.

Volt-free contact, where specified Heating & cooling

Chiller control

Configure a compatible external cooling input and verify temperature-based operation.

Approved switched control output Lighting

Hayward SmartPower 300W

Connect the tested 300W SmartPower supply, select its output zone, and verify the correct light response.

RS-485 smart transformer Relays & valves

Hayward Remote Relay

Enroll the tested remote relay and keep its bus address separate from an AUX terminal number.

RS-485 remote relay Lighting

Spa Electrics MULTI PLUS

Match the lamp profile and relay, then verify ON/OFF, colors and shows before adding a program.

AUX → external lighting relay Lighting

Hayward ColorLogic relay lighting

Match the lamp profile and relay, then verify ON/OFF, colors and shows before adding a program.

AUX → external lighting relay Lighting

Jandy WaterColors

Match the lamp profile and relay, then verify ON/OFF, colors and shows before adding a program.

AUX → external lighting relay Lighting

Pentair IntelliBrite lighting

Match the lamp profile and relay, then verify ON/OFF, colors and shows before adding a program.

AUX → external lighting relay Lighting

PAL / DMX lighting

Follow the PAL DMX tutorial from the communication connection to zones, colors and custom shows.

DMX data Chemistry & dosing

CO₂ dosing

Prepare the approved CO₂ assembly, connect the required feedback sensors, and commission pH control with your installer.

Dedicated CO₂ output Chemistry & dosing

Liquid chemical dosing through AUX

Connect an approved liquid dosing system, map its AUX output, and verify the feed rate and interlocks before automation.

AUX → approved dosing interface Controller & display

Controller backlight

Choose a built-in backlight preset without assigning a pool-light relay or changing pool equipment.

Built-in controller lighting Controller & display

Clyr Touch: setup and everyday control

Choose the correct operating mode, pair the display to the right controller, and understand manual control versus schedules.

Controller Mode or Screen Mode

Already using an earlier guide?

The original installation guides are still available in the menu, including TriStar, FloPro, IntelliFlo, AquaRite, AquaPure, IntelliChlor, valves and sensors. Use the guide that matches your hardware generation.